Gene & Terri Hinders

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Fan Shrouds FullSize Merc / Ford #4289

    Wayne,
    Hadn’t heard back from you from the e-mails I sent…just touching base to make sure you got the messages.
    Gene

    in reply to: Fan Shrouds FullSize Merc / Ford #4287

    Just sent you a bit of a lengthy reply via your e-mail…Thanks for the info!!
    Gene

    in reply to: Fan Shrouds FullSize Merc / Ford #4283

    Wayne,
    I may have found a shroud…but keep your eyes open just in case! I’m also needing some other pieces yet so if you do find one in the yards let me know, or if you have some extra pieces you’re needing to clear out let me know too.
    One other main piece we’re looking for is a LH power seat track for the bench seat…as well as some misc interior chrome and a couple of dash trim pieces.
    Thanks again!!
    Gene

    in reply to: Fan Shrouds FullSize Merc / Ford #4282

    Sounds like you live near heaven 🙂
    I’ve found some aftermarket ones for around the 100.00 mark and a ’66 used one for the same….the aftermarket ones make me nervous on the way they look in the pics. Was hoping a used one would be less but let me know what you find. There’s a few other parts we’re needing if you find a 65 with some good pieces still attached!!
    Do you have some pics of your 65? Ours can be seen on our FaceBook page The RoadHouse
    The Mrs picked it up for me as a birthday present and the running joke is I don’t know if she loves me or hates me. We ran out to CA to get a good frame (we’re in Iowa by the way…where are you?) and we just got the front clip/interior/engine&trans all taken off in preperation for the lifting of the body and the frame swap. This is all new territory for me! We’ve drag raced a 79 Fairmont for years and the fox-body and sbf stuff is second nature…the mid 60’s and fullsize stuff is all new.
    Thanks for the info/help/advice!!
    Gene Hinders

Viewing 4 posts - 1 through 4 (of 4 total)